Methodology & Reference Sources

At AquaScaper & TankLab, our aim is to make aquarium calculations understandable. That means explaining the measurements, formulas, and assumptions behind a result, while making clear where an estimate needs to be checked against actual conditions.

Reference Standards & Aquatic Formulas

  • Aquarium Volume & Weight: Volume calculations use the tank's internal dimensions and intended water level. Glass thickness needs to be accounted for when starting with external measurements; it should not be subtracted again from internal measurements. Substrate and hardscape displacement reduce the water volume. Filled-weight estimates also need to include the tank, substrate, rocks, equipment, and other supported items without counting the same mass twice.
  • Substrate & Hardscape Sizing: Substrate volume is estimated from the tank's footprint and average substrate depth. Converting that volume into a purchase weight requires a bulk-density estimate for the chosen product. Aquasoil, sand, and gravel vary, so product-specific information is preferable to a single assumed density.
  • CO₂ & the pH/KH Relationship: A commonly used freshwater approximation is CO₂ (mg/L) ≈ 3 × KH × 10(7 − pH), with KH expressed in degrees of carbonate hardness (dKH). This model assumes carbonate chemistry dominates the relationship. Other acids and buffers, including effects from some substrates, can make the estimate misleading. It is not a direct CO₂ measurement or a guarantee of a safe concentration.
  • Planted-Tank Fertilization: Dosing calculations relate the amount of a product added to the estimated water volume and its stated composition. Results need to distinguish elemental nutrients from compounds such as nitrate or phosphate. Product purity and the declared analysis of trace-element mixtures matter; a calculated addition does not establish a suitable dosing schedule for every aquarium.
  • Water-Change Nitrate Dilution: For one partial water change, the mixing calculation is Cafter = Cbefore × (1 − f) + Creplacement × f, where f is the fraction of water replaced. Repeated changes apply this calculation each time. The model assumes complete mixing and does not account for nitrate production, plant uptake, or other changes between water changes.

Practical Safety Boundaries

A calculator cannot confirm structural capacity, diagnose an animal's condition, or establish that a chemical treatment is appropriate. Large aquarium installations may need a site-specific structural assessment; total weight alone does not determine whether a floor can support them.

Check measurements and test results before making adjustments, follow product and equipment instructions, and stay within electrical ratings. Use calculated estimates alongside observations of the aquarium rather than treating them as instructions to dose or alter equipment.